Home > Windows Xp > Installation Failed E I386 Asms. Error Message

Installation Failed E I386 Asms. Error Message


That is why I think that the burn speed is the issue. Please refer to our CNET Forums policies for details. The following is a good guide with screenshots: http://www.windowsreinstall.com/winxphome/installxpcdrepair/indexfullpage.htm The only difference is that it starts off by assuming that you have booted to your Windows XP CD instead of running WINNT.EXE from hard drive files. The rest of the install-process was without problems, and I didn't expierience troubles, until... have a peek here

Reader? Add to Favorites Search Forums Advanced Search: New Posts: Today's Posts: Go to Page... Win XP ALL How-tos Win 10 Win 8 Win 7 Win XP Win Vista Win 95/98 Win NT Win Me Win 2000 Win 2012 Win 2008 Win 2003 Win 3.1 E-Home Office PC Games Con Games Drivers Linux Websites E-Photo Hardware Security Coding PDAs Networks iPhone Android Database CPUs Solaris Novell OpenVMS DOS Unix Mac Lounge Login» Register» Connect» Hardware & Devices ▼ General Hardware CPUs/Overclocking Networking See More... When I choose to boot to the Windows Cd using the original (legit) installation media WINDOWS XP Home Edition, service pack 1, windows setup begins, loads the files, notifies that setup is starting Windows, starts installing windows, notifies that it will complete in approximately 39 minutes and then generates almost immediately either setup log -(C:\WINDOWSsetuperr.log or -(D:\WINDOWS\setuperr.log depending on which partition I chose from the loader menu as explained above. other

I386\asms Download

But after running Service Pack 2, still in XP-home edition, OE persisted on starting up Main Identity, asked me for its Identity password (which I don't remember) The only way to read emails in OE was to undo SP2 by SystemRestore. Such opinions may not be accurate and they are to be used at your own risk. After getting the very same error message of everyone got, i swapped the installation cd to a different cd/dvd reader.

Ferguson > > > > "Souldealer" wrote: > > > Primary Problem; > > Post fine (FF) > > Windows copies files > > Reboots > > Starts actual install > > Fails with > > > > Fatal error > > An error has been encountered that prevents setup from continuing. > > > > One of the components that windows needs to continue setup could not be > > installed. > > > > The parameter is incorrect. > > > > Log file gives; > > > > Fatal Error > > Installation Failed: E\I386\ASMS. slartimitvar View Public Profile Send a private message to slartimitvar Find all posts by slartimitvar #12 07-11-2008, 04:48 PM ZotBot Offline Registered User Join Date: Jul 2008 Posts: 1 Quote: Originally Posted by slartimitvar I ran into this problem today with a newly slipstreamed SP3 volume licensed install CD.... ....and then burned it to DVD. Pulled out 1 of the 2 DIMM's, no difference. Download File I386 For Window Xp I burned the ISO to DVD and boom, it works!

Fatal Error: One of he components that Windows needs to continue setup could not be installed. Windows Xp Installation Failed I386 Asms I increased the point value to 300. One log message is kept on drive C: and the other is kept on Drive D:, both messages are very similar but not identical, thus -(C:\WINDOWS\setuperr.log contains a line that does not appear on the D: log, i.e: "Unstranslatable message. I can't progress through my windows install until this is fixed!!!

If I activate windows in the D: partition (if it can be done) does it replace the installation I did or does it become a second operating system for Windows XP Home edition service pack 2. The File Asms On Windows Xp Professional Service Pack 2 Cd Is Needed I tried copying the main-profile.local (that I had been using in XP-home) to a network profile with a similar name "main-profile.network" My pc got stuck an displayed the FATAL ERROR-SCREEN (twice) and afterwards I wasn't even offered the Profile-COPY to-option in My Computer/properties/user profiles any more...(greyed out) (of course the Copy to-function can be retrieved through system-restore: I get the same Fatal Error screen twice again and then it greys out again) SECOND PROBLEM is that when trying to use Remote Desktop Control from another machine to the "Main Profile.local" on my pc, it's access is denied: "cannot sign on because of account restriction" (translated from Dutch) Maybe my problem is caused by Outlook Express. The BIOS command is not working. Back to top #5 usasma usasma Still visually handicapped (avatar is memory developed by my Dad BSOD Kernel Dump Expert 22,718 posts OFFLINE Gender:Male Location:Southeastern CT, USA Local time:06:57 PM Posted 20 October 2007 - 06:45 AM Are you using the old CD to make the new copies?

  1. Just noticed it starts at > > > > post 27, have to look that up. > > > > > > > > Went to Microcrap site ASMS files are good, also I used same disk for this > > > > machine. > > > > > > > > 1st attempt, > > > > Everything in. (Yes I now know 32bit cant’t take 4 gig of mem but I’m not > > > > brave enough to go to Vista yet.) > > > > HD’s set to 3GB trans rate by jumper. > > > > Jmicron RAID drives to Floppy > > > > BIOS set to raid 1 > > > > > > > > 2nd attempt, > > > > Same but remembered to clear CMOS first > > > > > > > > 3rd attempt, > > > > Same but Intel Raid drives used > > > > 4th, > > > > Same but Bios left to IDE > > > > > > > > 5th, > > > > Removed 2 mem sticks from 2 & 4 > > > > Back to intel Raid > > > > > > > > 6th, > > > > Removed 2nd XFX card > > > > > > > > 7th, > > > > Set drive jumpers back to limit drives to 1.5gb trans rate > > > > > > > > Clues? > > > > Curtisw, Feb 21, 2008 #5 psaila_mike Guest RE: XP Install Fails: Installation Failed: E\I386\ASMS.
  2. Most of the posters in this thread are no longer here.
  3. Ferguson" wrote: > Assuming you can use the CD drive , it's the media. > -- > helpful?
  4. The drive is always non existing, next letter after last existing drive).I will appreciate your help.
  5. Help?

Windows Xp Installation Failed I386 Asms

Voting helps the web interface. > Holiday Lights: http://www.geocities.com/marfer_mvp/Xmaslgt.zip > Mark L. http://www.pcreview.co.uk/threads/xp-install-fails-installation-failed-e-i386-asms-error-message.3355722/ click "Yes" button. I386\asms Download Yes, I know that sounds strange, but it would commonly be used to upgrade a previous operating system like Windows 98 to Windows XP when run from within Windows 98. I386 Error When Installing Xp During setup you have the choice to convert the partition to NTFS anyway.

They're not on the Intel site ;( Help? http://thenewnexus.net/windows-xp/installation-failed-e-1386-asms-error-message.html Yes No Not yet What's that? now the installation goes smooth now. click "Yes" button. Asms File Missing Fix

Now, I have a floppy drive, but what I don't have is a floppy with SATA drivers on it. and try not to load or run other programs at the same time unless you have i gig or more ram on the computer..i find it better then nero or alcho120 or any other iso burning program out there.. I tried to install Win XP 3 times with this CD and got the same results. Check This Out I seem to remember however that I already tried to copy the i386\asms files using the COPY command and it failed.

Bios? Asms Windows Xp Service Pack 3 P pauses the tests and allows you to use M to set advanced options, and C resumes the tests. In fact booting from the new CD which is service pack 2 crashes the computer and restarting the windows setup simply rejects the new CD and asks for the old one.

The system registry may be damages.

The parameter is incorrect. Join our community for more solutions or to ask questions. I told you about my problems with copying this profile to a network profile, so I tried, while logging in as administrator, a manual copying-procedure (copy /paste) of C:\documents and settings\main-profile.local -> c:\documents and settings\main-profile.network This seemed to work well, it acts like an identical copy of main-profile.local, it even allows unrestricted access by Remote Desktop Control, BUT: Outlook Express will NOT PERMIT ME TO READ MY MAIL !! ( ) It opens Private-Identity all right, does NOT ask for my OE-Identity password, only asks for my internet-provider password, than receives new messages, but when trying opening a message it reads: ERROR in Outlook Express (or something of the kind) DOES ANYONE HAVE ANY IDEAS ABOUT THIS ?? The File Asms On Windows Xp Sp3 Is Needed Usb Report • #2 Johnw December 27, 2012 at 18:48:40 Power management options disabled in the BIOS have made Windows XP fail to install?You may have turned off the power management options in the BIOS because they were problematic, or you were advised to because they are not necessary on a desktop PC, but Windows XP requires them to be enabled or it will lock up during the installation process.

So the reason for the error message at the first installation attempt is because Winnt32.exe cannot be run in 16-bit "DOS Mode". ZotBot Same problem I had, with ASMS. View the setup log file. this contact form Good luck.